Posted by Gary (64.171.81.85) on October 25, 2001 at 18:20:32:
In Reply to: Power sharpening posted by Tony Aiello on October 25, 2001 at 18:09:19:
: ...Does any one know where I might get a motor specifically designes for power sharpening.
You would be better off setting up a pulley-driven system, with all the wheels on one axle. The wheel speed can be set by the ratio of the driving/driven pulley diameters.
There is a big advantage to this: You can stack a bunch of different abrasives on the axel. Good Luck!